You are here:
In this article we will focus on the 10 m³ amixon® HM twin-shaft mixer for the final homogenization of dietetic products. A batch often involves more than 40 different components. This 10 m³ amixon® HM 10,000 mixer is used for the final homogenisation of dietetic products.
This mixer type was developed for the mixing of particularly sensitive components. These include the goods resulting from freeze-drying or produced in the spray tower and agglomerator. These are primarily instant nutrients or agglomerated medicinal ingredients with excellent instant properties. Ideally, these goods would be…
Large-volume mixers that require only low electrical connected loads are always of interest when efficient and gentle homogenization is required. If no short mixing time is required here, but rather a cost-effective homogenizer that ensures a high mixing quality - regardless of the nature of the mixed materials, then the…
In fact, powder mixer inspection doors are used a lot. For every inspection, for every cleaning. First of all, it is important that the inspection doors can never open by themselves. This is perfectly achieved with the KwickKlamp® lock system shown above. The larger the inspection door, ...
The fascination of spices lies in the combination of essential oils, aromas, antioxidants, colorants, vitamins and minerals. They turn food into a sensory experience. A number of spices have been attributed with health benefits. Others have a preservative effect.
In this blog article we address some common questions from amixon® interested parties about the advantages of our innovative complete emptying and the wear factor of mixing plants.
Coating of all particles with food fat. Complete coating is demanding. Good result from the amixon® mixer: At first glance, it is not recognisable whether this product is coated with food fat or not.
Ground spices are mixed homogenously. Optionally, powdered or liquid additives can be added.
As many particle surfaces as possible should be coated with as little coating material as possible. For distribution, the coating material must be liquefied. This improves the wetting properties. The final product should flow well as a bulk material and the coating should be sufficiently abrasion resistant. This requires…